LIFIMAX Office and Industry Kit

$1 916.72 (ex. VAT)

In stock

LiFiMAX Office and Industry is a modular LiFi system that is easy to install in both small and large spaces to optimize cybersecurity levels. By using light signals, eavesdropping is not possible. LiFiMAX Office and Industry is also valuable in factory halls – warehouses where radio communication is prohibited or undesirable, while still allowing for secure wireless internet access.

The system consists of access points and photonic antennas. Each access point can connect to maximum six photonic antennas. Additionally, the access points and antennas can be interconnected, ensuring LiFi internet coverage throughout the entire space and enabling network access for any device equipped with a LiFiMAX® dongle (Plug & Play)  or by using our LIFIMAX Tablet. With the LIFIMAX controller software, LIFIMAX Office and Industry can be easily configured within the network.

The Lifimax Office and Industry Kit can connect up to 16 users/devices simultaneously. The USB dongle establishes the connection between the antenna and the device. The Lifimax Tablet has a direct connection to the antenna to receive the LiFi internet signal.

LiFIMAX Office and Industry  Kit :

  • 1 pc.  LIFIMAX  access point
  • 1 pc.  LIFIMAX  photonic antenna
  • 2 pcs  LIFIMAX  dongle USB stick

Optional :

In stock

Customized Offer

However, if you would like a customized quote for our modular Lifimax Office and Industry system, we kindly ask you to fill in the following information.

Enter the measurements of the area in which LiFiMAX Office and Industry will be used

x

General

  • Cybersecurity – Light waves are undetectable no eavesdropping
  • No electromagnetic radiation
  • 150 Mbps Down / 150 Mbps Up
  • Very low latency.
  • Easy installation.
  • Compatible with Linux, Windows, MacBook with type A and C USB ports
  • A maximum of 16 receivers ( USB Sticks) can be connected simultaneously to the same  Access point.

LIFIMAX Office and Industry system with Lifi signal:

Examples of possible configurations for LIFIMAX Office and Industry with Access Points (which do not emit a signal) and Photonic Antennas (which do provide a LiFi signal within the coverage area). The special blue cables (supplied) ensure the connection between the Access Points and the Photonic Antennas. Synchronization of the Access Points and antennas to extend the coverage area can be done through static or dynamic handover.

Based on the information you provide about the space and users, we can create a LIFIMAX installation plan, indicating where the Access Points and Photonic Antennas should be placed for optimal signal coverage, as illustrated in the example diagrams below.

Technical

LIFIMAX Office and Industry Access point

Dimensions  74 x 28 x 15 mm
Weight 40 g
Humidity tolerance Average ambient temperature 70% (RH)
+/-25° C
Storage temperature -40 to +100° Celsius
Operating temperature range -25° to +85° Celsius
Transmission mode Half duplex
Protection class IP30
Interfaces Interfaces USB 2.0 or USB 3.0
Installation Plug-and-play
Via the Photonic Antenna LED 940 nm (close to infrared)
LiFi Communication Standard ITU-T G-9991
Security AES 128 encryption, 802.1X,
VLANs, Captive portal via the
LiFiMAX®Controller
Connection continuity Provided under the same
TxRx-LFMX-1AP-RevF and its
Photonic Antennas and between
Access Points (roaming) with the
LiFiMAX®Controller
Total debit 215 Mbps uplink in Phy layer (G.vlc)
215 Mbps downlink in Phy layer (G.vlc)
Power consumption Maximum 3W, average 2,1W < 1,7W without LiFi connection
Power supply USB standard
Certifications EC marking including RoHS, IEC/
EN 61000 (EMC) and IEC/EN
62471 (eye safety) standards, IEC
60825-1, IEC 60825-12
OS Compatibility Plug-and-play, Windows (From 7), MacOS, Linux, Unix, Android, iPad Pro,
Hololens, any USB- C devices

LIFIMAX Office and Industry Photonic Antenna

Dimensions  71 mm / height 28 mm
Weight 80 g
Humidity tolerance Average ambient temperature 70% (RH)
+/-25° C
Storage temperature -40 to +100° Celsius
Operating temperature range -25° to +85° Celsius
Transmission mode Half duplex
Protection class IP30
Interfaces 1 single RJ45 cat 7 connector (TIA /
EIA 568A or 568B) towards the TxRxLFMX-1AP-RevF is strongly recommended to use Oledcomm cables
Installation Plug-and-play
Via the Photonic Antenna LED 940 nm (near infrared)
LiFi ITU-T G-9991
communication standard
Security AES 128 encryption, 802.1X,
VLANs, Captive portal via the
LiFiMAX®Controller
Connection continuity Ensured under a single TxRx-LFMX1AP-RevF and its antennas and between Access Points
Total debit 215 Mbps uplink in Phy layer (G.vlc)
215 Mbps downlink in Phy layer (G.vlc)
Power consumption 3W provided by the TxRx-LFMX-1AP-RevF
Power supply 24V DC powered by the TxRx-LFMX-1AP-RevF
Certifications EC marking including RoHS, IEC/
EN 61000 (EMC) and IEC/EN
62471 (eye safety) standards, IEC
60825-1, IEC 60825-12
Mounting Surface or flush mount type

LIFIMAX Office and Industry – USB Dongle Stick

Dimensions  74 x 28 x 15 mm
Weight 40 g
Humidity tolerance Average ambient temperature 70% (RH)
+/-25° C
Storage temperature -40 to +100° Celsius
Operating temperature range -25° to +85° Celsius
Transmission mode Half duplex
Protection class IP30
Interfaces Interfaces USB 2.0 or USB 3.0
Installation Plug-and-play
Via the Photonic Antenna LED 940 nm (close to infrared)
LiFi Communication Standard ITU-T G-9991
Security AES 128 encryption, 802.1X,
VLANs, Captive portal via the
LiFiMAX®Controller
Connection continuity Provided under the same
TxRx-LFMX-1AP-RevF and its
Photonic Antennas and between
Access Points (roaming) with the
LiFiMAX®Controller
Total debit 215 Mbps uplink in Phy layer (G.vlc)
215 Mbps downlink in Phy layer (G.vlc)
Power consumption Maximum 3W, average 2,1W < 1,7W without LiFi connection
Power supply USB Standard
Certifications EC marking including RoHS, IEC/
EN 61000 (EMC) and IEC/EN
62471 (eye safety) standards, IEC
60825-1, IEC 60825-12
OS Compatibility Plug-and-play, Windows (From 7), MacOS, Linux, Unix, Android, iPad Pro,
Hololens, any USB- C devices

Coverage area ( m2) depend on distance between receiver and access point.

The Lifimax Dongle allows the device to which it is connected to establish a Lifi connection.

Once the dongle is placed in the coverage area of a transmitter ( Access point Compact / Photonic Antenna ) ,

The user will be able to enjoy high speed and radiowave free Lifi connection.

Controller

LIFIMAX Office and Industry Controller :

The LiFiMAX®Controller is at the heart of the LiFiMAX® Office and Industry. It is a software application that interfaces the LiFiMAX® Access Points with the client’s network, securing and managing them remotely, while providing additional connectivity features and administration tools to the network manager.

Features offered by the LIFIMAX®Controller – Oledcomm

Here is the roadmap for the next versions of the LiFiMAX®Controller.

LiFiMAX®Controller v2.2.4: Available and included

  •  Software upgrade and update module for the Controller
  •  Security management (firmware encryption, …)
  •  List of AP and their connection information, status, Mac address, …
  •  List of EP and connection information, status, Mac address, …
  • Management of admin accounts and passwords
  •  Fast handover module with dynamic bandwidth allocation
  •  802.1X authentication management
  •  VLANs at the End Point
  •  Master/Slave AP management to facilitate admin
  •  Enhanced security
  •  Reporting and Data Analytics module (syslog)
  •  Web services and API module
  •  Security update

Client must have a DHCP server. 

Subscription to the LIFIMAX controller :  annual license and annual license fees are mandatory.

Content

In the box  Lifimax Office and Industry kit:

  • 1 pc. LIFIMAX  access point
  • 1 pc.  LIFIMAX photonic antenna
  • 2 pcs  LIFIMAX  USB stick
  • Special RJ 45 cable for  connection between Antenna  and Access point
  • Mounting kit
  • Documentation
  • NOT included POE + cable for connection between Access point  and modem / switch
Go to Top